95-3 Grind, Flathead Core

As of July 30th, 2019, DynoCams will no longer be able to provide flathead cast cores for stock or hot stock grinds. These cast cores have not been produced by Briggs and Stratton for many years and there is no secondary supplier. We will, however, still grind stock profiles if you can provide a cast core meeting the following criteria:

• Cam journals free of rust, damage, or excessive wear

• Cam gear is free of rust, damage, or excessive wear

• The intake and exhaust base circles are no less than .725

Description

• This fast ramp, non-symmetrical cam was the #1 selling stock cam in the USA until the introduction of the 7X in 2001. It's hard on the valve train, and is recommend you use billet lifters and beef up the tappet bores.
• The lobes are hardened for extra durability, extending the life of this cam.

Specs